The Buckaroos® Dial-A-Miter wheel chart gives you guidance when making Long Radius and Short Radius Elbows. Just dial in the pipe size and you see the throat and heel measurements, angle of cut and number of miters required for each.
Standard Rule with Tinners and Other Sheet Metalworkers
Tempered Medium-Weight Steel
Hole in One End for Hanging
Markings are Black for Easy Reading
One Side Upper Edge Marked Inches to 1/16ths
Reverse Side has Formulas for Calculating...
Easily identify pipe size in IPS, CTS, and CPVC measurements up to a 12” Iron Pipe Size O.D.
This pipe caliper includes a handy IPS to CTS conversion chart and extends to a 14” ruler.
Back of blade provides scale that measures up to 3' diameters
Polymer-coated blade withstands abrasion for long life
Chrome high-impact ABS case is job site tough
Slim case fits easily in pocket
Secure blade lock won't creep during...
3/4" X 2', 1/32" Thick, 1-Fold, Tempered Steel Rule
This Brings Rule to a Firm Stop When Opened Straight
Riveted Joint Has Large Side Washer and a Stop
Legible, Permanent, Deeply Etched Black Markings
Lower Edge on One Side Graduated to 1/16ths of an...
This depth gauge is very useful for determining insulation thickness up to 6” with minimal damage to a vapor retarder.
An especially small diameter metal rod with pointed end will bottom out on the pipe or duct surface to derive a thickness...
Lay out regular equal tee templates for 1" to 12" pipe in seconds.
Made of durable ABS thermal plastic. Will not rust or corrode.
Only 7" x 11" and 11/16" thick makes the Tee Master light weight and easy to carry.
The Tee Master has a 1" to 6" scale...
Easily convert iron pipe sizes to copper tube sizes.
Useful for mechanical engineers, plumbers, HVAC installers and pipe insulators.
3 pieces per pack.
Measures up to 16” iron pipe diameter.
Made from .030 white PVC, and sized at 3.5” X...
Scribe commonplace trim lines on galvanized sheet metal quickly and accurately.
Ten pre-set scribing depths from 1/8” to 1”(3 to 25 mm).
Each scribing depth size features a dual edged point to create clean, readable and...
For measuring iron pipe & copper tubing.
Measures pipe sizes from 1/4" to 12".
Sturdy construction-nickel plated steel, corrosion resistant.
Accurate and fast adjusting.
For circles up to 32” (81 cm)
Points are easily resharpened or replaced. Nickel plated steel body.