The Buckaroos® Dial-A-Miter wheel chart gives you guidance when making Long Radius and Short Radius Elbows. Just dial in the pipe size and you see the throat and heel measurements, angle of cut and number of miters required for each.
Standard Rule with Tinners and Other Sheet Metalworkers
Tempered Medium-Weight Steel
Hole in One End for Hanging
Markings are Black for Easy Reading
One Side Upper Edge Marked Inches to 1/16ths
Reverse Side has Formulas for Calculating...
3/4" X 2', 1/32" Thick, 1-Fold, Tempered Steel Rule
This Brings Rule to a Firm Stop When Opened Straight
Riveted Joint Has Large Side Washer and a Stop
Legible, Permanent, Deeply Etched Black Markings
Lower Edge on One Side Graduated to 1/16ths of an...
Lay out regular equal tee templates for 1" to 12" pipe in seconds.
Made of durable ABS thermal plastic. Will not rust or corrode.
Only 7" x 11" and 11/16" thick makes the Tee Master light weight and easy to carry.
The Tee Master has a 1" to 6" scale...
This depth gauge is very useful for determining insulation thickness up to 6” with minimal damage to a vapor retarder.
An especially small diameter metal rod with pointed end will bottom out on the pipe or duct surface to derive a thickness...
This layout tool makes it easy to remember how to layout a 16 point gore
Step by step instructions included with each rule
This 6” x 6” square also has a protractor for laying out tee patterns
Made of 16 gauge steel, laser etched with a...